I have a Juniper Netscreen 25 that I attempted to do a factory reset on using the reset pin in the front of the device. After the reset, the status lights show green, and the ethernet ports light up and flash when somethings plugged into it.
However, I can't get into the device at all. It doesn't connect using the console port, and when I attempt to get in through the web interface, it doesn't appear to be the default IP.
I tried the factory reset again using the pin, however no matter how long I hold the pin in, the lights stay green and nothing happens.
I've attempted to contact Juniper but this was an EOL product in 2010.
Any troubleshooting steps to recommend? Any help is appreciated.
Thanks.