Hey all, I am running into a problem trying to configure some vlans.
Here is what I have.
Dlink dgs-3650 switch
IBM Blade center with a BNT Layer 2/3 Gigabit Ethernet Switch Module
ESXI 5.1
I am trying to configure a separate vlan for a DMZ server.
Here is my configuration so far.
I have created vlan 800 on the switch, assigned 3 ports to it.
1 port goes to the ibm blade center swtich (port 35) , 1 port go to the firewall port.(port 36)
i created a interface on my gateway and assigned it an ip address.
so, here is where it gets fuzzy.
Ok So port 35 going to my blade center switch is tagged, the other 2 ports are set to "egress"
on the blade center switch, i created vlan 800, assigned an internal and external port to it (int 1b, and ext6)
on the ESXI server, i created a virtual switch, assigned it a vlan, and assigned a host.
I am not getting out anywhere, cant seem to ping or get out anywhere from there.
my guess is i am not configuring the swtich on the blade correctly.
any help?