Hi all,
I need some help...
I've stacked 2 x Dell PowerConnect 6248 with stacking modules and cables in a Master/Standby config.
I've created 3 LAGs with 4 ports (2 ports on either switch) across the switches with LACP (each LAG is meant for a Hyper-V Host Server) with Channel 1, 2 and 3 set to Trunk mode. I've then created VLAN 100 and assigned it to all 3 LAGs with tagging.
On each Host Server I've Teamed 4 x Intel NICs and applied Dynamic Link Aggregation and then tagged VLAN 100 and given it an IP address on the 10.10.100.X range. I've done this on all three Host servers and plugged the relevant cables into the switch ports.
In the switch GUI I notice under LAG configuration... the LAG status displays down. How can I get it up?
I'm running a continuous ping from host server to host server but I'm not getting a reply. Can anyone help please.