Hello,
I have a PowerConnect 6248 that I've been trying to configure a port on.
The step's i've taken are as follows:
configure
interface ethernet 1/g16
switchport mode access
switchport access vlan 230
end
When the port is shutdown, show vlan shows 1/g16 on vlan 230
however, when the port is enabled, show vlan no longer shows 1/g16 on vlan 230.
This only happens when the port is plugged into. When the port is not in use, whether the port is shutdown or not, show vlan shows it on vlan 230.
Does anyone know why this is happening, or how I can resolve it without power cycling the switch?
Thanks in advance